Sealprim is nanohybrid, transluscent flowable dental composite for sealing pit and fissures.
It is used in the sealing of deciduous and permanent teeth.
Available in a 1 g syringe.
Packages:
1 x 1 g
| Category: | Filling materials and accessories |
|---|
Properties:
- Composition: mixture of dimethacrylate resins: BisGMA, TEGDMA, UDMA, BisEMA; mineral fillers (20 wt%): Al-Ba-B-Si glass, fumed silica, photoinitiator (CQ:DMAEMA). The size of inorganic filler particles is between 20 nm and 2.0 μm.
- Does not require the use of a bonding system however, if needed, it can be used with any standard, light cured bonding systems.
- Quick polimerysation: 3 mm in only 5 seconds
- Instant application: 5 sec without using adhesive system
- Sealing is a painless procedure performed by dentists and dental hygienists.
- A properly performed sealing procedure is an effective and long-lasting protection against dental caries. As a result, a high degree of pulp mineralisation makes the sealed tooth naturally decay-resistant.
Method of use:
Etching:
1. Etch the surfaces intended for sealing with Etchgel for 20-40 s, paying special attention to placing it also in the bottomof the fissure.
2. Rinse thoroughly with a strong stream of water and carefully dry the tooth surface. If the appearance of the etched enamel is not chalky white, repeat the etching process. If any contamination occurs, the surface should be re-etched for about 10 s.
Sealing:
1. In order to properly dispense the material from the syringe, unscrew the cap and attach the disposable applicator tipby twisting it securely onto the luer-lock of the syringe. Make sure the dispensing system is working properly by dispensing a small amount of the material onto a mixing pad or gauze. If this is completed satisfactorily, you can start working with the patient.
If the material does not flow out properly, replace the applicator tip with a new one.
After you have finished working with the patient, unscrew and discard the used applicator and recap the syringe.
2. Thoroughly apply Sealprim onto the etched tooth surface.
3. Cure in accordance with the polymerisation table.
4. Use an explorer to ensure pits and fissures are sealed.
5. Clean and rinse sealed surfaces immediately after applying sealant.
